+86
I. Basic Parameters
OE Part Number: 1601040-150
Accessories Name: Diaphragm Spring Clutch Pressure Plate Assembly Clutch pressure
Applicable models: Isuzu series medium trucks and commercial vehiclesSpecification size: 350mm outer diameter tension diaphragm spring pressure plate
Net weight: 18.555g, Gross weight 19kg
Complementary model: ISC810
Second, Core Functions
1. Relying on a diaphragm spring to provide clampingforce, the clamping plate is pressed tightly onto theflywheel, and the engine power is stably transmitted.
2. When stepping away from the pedal, the releasebearing pushes the diaphragm spring to separateand cut off the power to shift gears
3. The surface of the cast ironast heat dissipation, Wear-resistant, heavy-dutypressing plate is not easily
thermally deformed or slippedunder working conditions.
Three Fault replacement determination
1. The vehicle accelerates and skids. The rotational speed surges, no increase in vehicle speed, heavy loadPowerless
2. Incomplete separation, gear blocking, and severe start vibration
3. Diaphragm spring fatigue, disc surface ablation and grooving, Pedal travel suddenly
High and low
4. Friction pad wears rivets, Scratch the plate plane and must be fixed.Set replacement
Four. Core Product Advantages
1. One-piece cast clutch cover + thickened wear-resistant cast iron disc surface,
It is not easy to warp or deform at warm temperatures.
2. Imported high-elasticity diaphragm springs, durable tension, and lightweight pedals
Moderate without hardness
3. Original factory installation hole positions, non-destructive direct installation, requiring grinding and modification
4. Plant dynamic balance, pressure testing, heavy-duty slope climbing without slipping,
Long service life
5. Compatible with the original Isuzu 350 clutch
system, can be paired with clutch plates of the samemodel, and a complete set of release bearings.
5. Installation Precautions
1. Before installation, check the flywheel planefor any ablation, grooves, or damage. Surfacerepair or replacement of the flywheel is required.
2. The plate surface and the friction surface of the clutch plate must not be contaminated with engine oil or grease.
Failure caused by direct slipping due to oil exposure
3. It is recommended to use the three-piece clutch set (pressure plate + clutch plate + separation shaft)Synchronous replacement
4. After assembly, adjust the free stroke ofthe clutch pedal and low-speed break-in.Avoid prolonged half-clutch at 50 km.
